MAINTENANCE/SERVICE
Form 169469/169470/169471 158 Revision C
7.8.11 ENGINE SPEED
The maximum and idle engine speeds are
factory set to the specifications. See Section 4.2
Specifications. If specified speeds cannot be
maintained, see your Windrower dealer.
IMPORTANT
Do not remove any seals from injector
pump; removal of seals will void the
engine warranty.
7.8.11.1 Throttle Adjustment
The engine speed is controlled with the throttle
lever that is connected to an electronic sensor
inside the console. The throttle lever in the cab
should move the throttle sensor the full range
between slow speed stop and full RPM stop
without contacting the console at either position.
If the throttle lever is contacting the console and
interferes with specified engine speeds, the
sensor position possibly requires adjustment.
See your Windrower dealer.
To Next Page
Loading...
