MAINTENANCE/SERVICE
Form 169469/169470/169471 125 Revision C
7.5 MAINTENANCE PLATFORMS
Swing away platform/stair units are provided on
both sides of the windrower for access to the
operator’s station and engine bay maintenance.
7.5.1 OPENING/CLOSING PLATFORMS
a. Push latch (A) down and pull platform (B) toward
walking beam until it stops and latch re-engages
in open position.
b. To move platform back to closed position,
release latch (A) and move platform forward until
it stops and latch re-engages.
7.5.2 OPENING/CLOSING PLATFORM FOR
MAJOR SERVICING
To improve access to the hydraulics plumbing or
battery, the platforms can be swung away from
the windrower. Left side cab-forward platform
shown.
a. Open engine compartment hood to lowest
position.
IMPORTANT
Failure to open hood will result in damage
to the hood when the platform is
repositioned.
b. Unlock latch (A) and move platform (B) toward
open position but do not lock in full aft position.
c. Remove nut and bolt at frame and swing link (C)
clear of valve block or battery.
d. At the same time pull front (cab-forward) end of
platform away from frame while moving it
towards the walking beam. Aft corner (D) of
platform should project slightly into engine bay
when optimum opening is reached.
(continued next page)
To Next Page
Loading...
