MacDon M205 2010 - Interval Maintenance

MAINTENANCE AND SERVICE
Form 169469/169470/169471 196 Revision C
7.13.2 INTERVAL MAINTENANCE
INTERVAL
SERVICE
FIRST USE
Refer To BREAK-IN INSPECTIONS (previous page).
ANNUALLY *
1. Change Fuel Tank Vent Line Filter.
2. Check Battery Fluid Level.
3. Check Battery Charge.
4. Check Anti-Freeze Concentration.
5. Cycle A/C Blower Switch To Distribute Refrigerant Oil.
6. Check Steering Control Linkages.
END OF
SEASON
Refer To Section 6.3.9 STORAGE.
10 HOURS OR
DAILY
1. Check Tire Inflation.
2. Check Engine Oil Level.
3. Check Engine Coolant Level At Reserve Tank.
4. Clean Radiator, Hydraulic Oil Cooler, Charge Air Cooler, and A/C Condenser.
5. Check Hydraulic Oil Level.
6. Drain Fuel Filter Water Trap.
7. Fill Fuel Tank.
8. Check Hydraulic Hoses and Lines For Leaks.
50 HOURS
1. Grease Caster Pivots.
2. Grease Walking Beam Center Pivot.
3. Grease Top Lift Link Pivots.
4. Grease Forked Caster Spindle Bearings.
5. Clean Cab Fresh Air Intake Filter.
6. Check Gear Box Oil Level.
100 HOURS OR
ANNUALLY *
1. Clean Cab Air Return Filter.
200 HOURS OR
ANNUALLY *
1. Check Drive Wheel Lubricant Level.
2. Grease Formed Caster Wheel Hub Bearings.
3. Check Wheel Nut Torque.
500 HOURS
1. Change Engine Oil and Filter (or Annually).
2. Change Fuel Filters.
3. Change Gearbox Lubricant.
4. Change Charge System and Return (if applicable) Hydraulic Oil Filters.
5. Check Safety Systems (or Annually).
1000 HOURS
1. Change Engine Air Cleaner Filter Element.
2. Change Drive Wheel Lubricant.
3. Check Engine Valve Tappet Clearance.
1500 HOURS
1. Change Hydraulic Oil.
2. Change Lift Filter.
2000 HOURS
1. Perform General Engine Inspection
.
2. Change Engine Coolant.
* IT IS RECOMMENDED THAT ANNUAL MAINTENANCE BE DONE PRIOR TO START OF OPERATING
SEASON.