A standard set of particles is available for selection in the SOP (using the first
Analysis dialogue). More can be defined by a user, but the following parameters
must be specified accurately:
.
Refractive Index (Real) – describes the amount of scattering that takes
place as a result of light interacting with the particle.
.
Refractive Index (Imaginary) – the imaginary or complex refractive in
-
dex. This describes the amount of absorption that takes place as the light
enters the particle.
.
Density – the density in g/cm
3
. This is used to calculate Specific Surface
Area (SSA). If you want to include the SSA as a derived parameter you
must complete this field.
The residual shown in the Measurement Parameters view indicates how well
the calculated data fitted the measurement data.
CHAPTER 10
Spraytec Page 10.17
To Next Page
Loading...
