.
The power cord set must have a minimum current capacity of 10A (7A Ja
-
pan only) and a nominal voltage rating of 125 or 250 volts AC, as required
by each country’s power system.
.
The area of the wire must be a minimum of 0.75mm
2
or 18AWG, and the
length of the cord must be less than 3m.
The power cord must be routed so it is not likely to be walked on or pinched by
items placed upon it or against it, or become wet. Particular attention must be
paid to the plug, electrical outlet, and the point where the cord exits the product.
WARNING: Do not operate this product with a damaged power cord set. If
the power cord set is damaged in any manner, replace it immediately.
WARNING: Do not use the power cord received with this product on any
other products.
Additional services
For remote support over the Internet, a direct Internet connection is required.
Computer usage
The Spraytec software can be run on a network but this is not recommended as
running other software at the same time may impact on the speed of the Spraytec
software.
APPENDIX C
Spraytec
Page C.4 MAN 0368
ILL 7360ILL 7360
To Next Page
Loading...
