Changing the computer
If the computer used with the instrument is changed, follow this procedure.
'
Note
.
If the computer already has an older version of the Spraytec software,
remove this before installing the new version. Use the Add/Remove
Programs function in the Windows Control Panel.
$
To install the software:
.
Insert the Spraytec CD in the CD drive.
.
If Autorun is enabled on the computer the software will start to install au
-
tomatically. Follow all on-screen instructions to complete the installation.
.
If Autorun is not enabled select Start-Run-Setup.exe and follow the
on-screen instructions.
'
Note
.
If the software is subsequently updated with a new version, any custom
reports, parameter settings, SOPs, etc. will be preserved.
APPENDIX E
Spraytec Page E.3
To Next Page
Loading...
