Malvern Instruments Spraytec - Printing

$
To copy text to the clipboard:
.
Click in the window and select Edit-Copy Text.
.
The Select Range of Records to Copy dialogue appears. If required,
change the selection of records using the Selection Mode as described in
Chapter 6.
.
Click the Configure button to open the Select Parameters to Export
dialogue shown above.
.
Use the Add-> and <-Remove buttons to build the Parameters to Ex
-
port list. These will all be included in the exported text file. Use the Move
up or Move Down buttons to reorder parameters as appropriate.
If desired a file defining the list of parameters can be created and used each
time, loaded with the Load button. The online help gives full details on
this and the other parameters.
.
Click the OK button.
Printing
The procedure for printing out information is different for the Size History and
PSD windows. Both are detailed below.
Information can be printed to a physical printer or a .pdf file.
$
To print from a Size History view:
.
Click on the Size History view and choose File-Print or File-Print to
PDF to display the Select Range of Records dialogue.
.
Use the and buttons if necessary to set up the page and printer.
.
Select the records required as described in Chapter 6 and click the OK but
-
ton.
$
To print from a PSD window:
.
Click on the PSD window and choose File-Print or File-Print to PDF
to display the Print dialogue:
CHAPTER 7
Spraytec Page 7.5