MAN B&W 19.10
Page 1 of 11
MAN Diesel
List of Standard Tools for Maintenance
The engine is delivered with all necessary special tools for scheduled maintenance. The extent of the tools
is stated below. Most of the tools are arranged on steel plate panels. It is recommended to place them
close to the location where the overhaul is to be carried out, see Section 19.11.
All measurements are for guidance only.
Mass of the complete set of tools: Approximately 2,450 kg
Cylinder Cover, MF/SF 21-9010
1 pcs Tool panel incl. lifting chains, grinding mandrels,
extractor tools etc.
Cylinder Unit Tools, MF/SF 21-9014
1 pcs Tool panel incl. pressure testing tool, piston ring
expander, stufng box tools, templates etc.
1 pcs Guide ring for piston
1 pcs Lifting tool for piston
1 pcs Support iron for piston
1 pcs Crossbar for cylinder liner, piston
1 pcs Lifting tool for cylinder liner
1 set Measuring tool for cylinder liner
1 set Test equipment for Alpha Lubricator
Crosshead and Connection Rod Tools, MF/SF 21-9022
1 pcs Tool panel incl. suspension and lifting tools,
protection in crankcase etc.
1 pcs Guide shoe extractor
Crankshaft and Thrust Bearing Tools, MF/SF 21-9026
1 pcs Tool panel incl. lifting, testing and retaining
tools etc.
1 pcs Lifting tool for crankshaft
1 pcs Lifting tool for thrust shaft
1 set Feeler gauges
Control Gear Tools, MF/SF 21-9030
1 pcs Tool panel incl. pin gauges, chain assembly
tools, camshaft tools etc.
Exhaust Valve Tools, MF/SF 21-9038
1 pcs Tool panel incl. grinding-, lifting-, adjustment-
and test tools etc.
Fuel Oil System Tools, MF/SF 21-9042
1 pcs Tool panel incl. grinding, lifting, adjustment and
assembly tools etc.
1 set Fuel valve nozzle tools
1 set Toolbox for tting of fuel pump seals
1 pcs Probe light
1 pcs Test rig for fuel valve
Turbocharger System Tools, MF/SF 21-9046
1 set Air cooler cleaning tool
1 set Guide rails, air cooler element
1 pcs Compensator, dismantling tool
1 pcs Travelling trolley
General Tools, MF/SF 21-9058
1 set Pump for hydraulic jacks incl. hydraulic
accessories
1 set Set of tackles, trolleys, eye bolts, shackles, wire
ropes
1 set Instruments incl. mechanical / digital measuring
tools
1 set Working platforms incl. Supports
1 set Hand tools incl. wrenches, pliers and spanners
Optional Tools, MF/SF 21-9062
1 pcs Collar ring for piston
1 pcs Support for tilting tool
1 set Measuring tool for main bearing clearence
1 pcs Valve seat and spindle grinder
1 pcs Wave cut machine for cylinder liner
1 pcs Wear ridge milling machine
1 pcs Work table for exhaust valve
Hydraulic Jacks, MF/SF 21-94
It is important to notice, that some jacks are used on
different components on the engine, Fig. 19.10.06
MAN B&W S50MC-C7/8 198 64 31-6.0
To Next Page
Loading...
Need help?
General
