AXLES/DRIVE SHAFTS/WHEELS AND TIRES CD3340B/YB4411
8-14
Published 04/07/2015 Control # 569-00
c. Remove all of the rollers (Figure 8-42) and check
their condition. If any gear pin shaft is damaged,
replace the entire planetary carrier assembly.
NOTE: Before disassembling the splined sleeve, it is
advisable to secure it with a hoist or other
supporting device to inhibit it from accidentally
falling and injuring the mechanic or causing
damage to the hub.
6. Remove the retaining ring (Figure 8-43) from the u-joint
shaft using suitable pliers.
7. Remove the axle shaft washers (Figure 8-44).
8. Unscrew and remove the nine fastening screws
(Figure 8-45) from the hub-lock ring gear.
9. Remove the hub-lock gear from its housing by using two
of the removed screws as jack screws. Screw the two
screws into the threaded extraction holes (Figure 8-46).
Reference Only
To Next Page
Loading...
