Replacing a Print Head Replacing and Adjusting the Print Heads
9-4 Sprinter User's Manual
Figure 9-4: The Print Head Stops
18. Tighten the two groups of the MOUNTING SCREWS so that the PRINT HEAD
is touching the metal surface. Check that at no point along the P
RINT
HEAD'S length is there a gap between it and the COOLING CHANNEL and
that no cables are caught in between.
19. Reconnect the cables to the P
RINT HEAD.
20. Cut the S
UBSTRATE next to the SUBSTRATE ROLL, and remove it from the
printer.
21. Reinstall a new S
UBSTRATE on the printer.
Print Head Stops
To Next Page
Loading...