THIS PRODUCT IS INACTIVE!
Please contact Mathers Controls for support information.
Page 3
2.2 SUPPLIED BY INSTALLER
2.2.1 Tools Required For Installation
Anti-static wrist strap is included with Actuator.
Wire cutter (Recommend Thomas & Betts WT-2000)
Wire stripper (Recommend Thomas & Betts WT-2000)
Wire crimper (Recommend Thomas & Betts WT-2000)
7/16" Socket and medium extension
3/8" Wrench
7/16" Wrench
Screwdriver - medium phillips head #2
Screwdriver - medium straight slot
Screwdriver - small straight slot
Hole saw - 1" (25,4mm)
Drills - 9/32" (7,2mm) and 7/32" (5,6mm)
2.2.2 Push-Pull Cables
Type 33C push-pull cables. (two per engine) The cable
length is measured from end of thread to end of thread.
Cables are usually stocked in one foot (0,3m) increments.
2.2.3 Push-Pull Cable Connection Kits
The kits provide hardware to connect the Type 33C cable
to the engine throttle and transmission. Many engines
and out drives are delivered with factory mounted kits.
Morse standard connection kits are listed in Section 9. A
Universal Mounting kit, listing parts and dimensional data,
is shown in Section 10.
2.2.4 Control System Power 'ON' - 'OFF' (See Figure 3)
The power for controls should come from the same power
distribution panel as the other required engine function.
Each Actuator requires a switched 10 amp circuit breaker
with manual reset. If this is not possible, a circuit
breaker and relay may be mounted near the battery and
To Next Page
Loading...
Need help?
General