THIS PRODUCT IS INACTIVE!
Please contact Mathers Controls for support information.
Page 29
8.5 'HI' IDLE 'LO' IDLE (OPTIONAL)
The MicroCommander Control offers an option of two (2) engine
idle RPM settings. The normal LOW ('LO') idle RPM is set
mechanically, adjusting the ball joint connector at the engine. A
second 'HI' idle RPM can be set electrically. Pushing the station
transfer button will alternately move the engine idle setting
back and forth between 'LO' idle and 'HI' idle. To synchronize
two (2) engines in 'HI' idle, place both engines in 'Warm-up'
Mode as described under ENGINE START.
8.6 MASTER STATION ISOLATION (OPTIONAL)
The main starting station has the option of a switch that will
prevent control transfer to any other station unless the operator
positions the switch to allow transfer. With the switch in
"normal" position, other stations can take control. In "isolate"
position, control is isolated to the master station.
8.7 SYNCHRONIZATION (ADDITIONAL OPTION)
A green LED light is added to the starboard control lever.
Synchronization is automatic when both engines are in 'AHEAD'
in the cruise range. When engine RPM's are within 15% of one
another the green LED will blink, indicating the system is
working to synchronize. When the green LED is full 'ON' the
engines are in sync. When the light is out sync is 'OFF'.
To Next Page
Loading...
Need help?
General