7
u n d e r s t a n d i n g t h e a n a l y z e r
r
To clean the outside surfaces of the EasyStat analyzer, use a clean-
ing agent consisting of a 10% bleach (0.4-0.6% NaClO) solution.
Dampen a cloth with solution to wipe down all outside surfaces.
Protective clothing and gloves are recommended. Refer to the
Analyzer Surface Cleaning/Storage instructions outlined under
Replace Components in Operating the Analyzer.
To clean any component, use only water or bleach (NaClO) solu-
tions. DO NOT use solvents (examples: methyl alcohol, ethyl alcohol,
isopropyl alcohol).
s
BIOHAZARD
All biological samples should be
considered biohazardous.
Any replaceable component which
comes in contact with biologi-
cal samples, including the sample
probe, electrodes, sensor module,
pump tubing, valve module and
reagent module may contain con-
taminated material. Treat all com-
ponents, during use and disposal,
as you would any biohazardous
material.
To Next Page
Loading...