micro-trak SprayMate II - NH3 Specific Installation

74 pages

Save Page as PDF

To Next Page

To Previous Page

NH3500 Kit P/N 01120

he Liquifier

™

it P/N 01097

Appendix G: SprayMate II - NH3 Specific

Component Parts for SprayMate II for NH3 Kits

Main Page

Micro-Trak Warranty3
Table of Contents4
Table of Contents5
Component Parts and Assembly Hardware6
Installation8
- Mounting the Display Console, Switch Box, and Run/Hold Switch Kit8
- Spraymate II System Overview with Ignition Switch Hookup9
- Spraymate II System Overview with Optional Power Switch10
- Spraymate II Wiring Overview11
- Electrical Installation12
Spraymate II Boom Connections13
Speed Sensor Installation14
- Magnets14
- Attaching Magnets14
- Connecting the Speed Sensor Cable16
- Speed Sensor Options16
Spraymate II Plumbing Overview (Bypass)17
Spraymate II Plumbing Overview (Inline)18
Mounting and Plumbing Flowmeter19
- Installing Flow Sensor Cable19
- Remote Run/Hold20
Care and Maintenance20
- Manual Pressure Relief Valve21
- Range Adjust Valve21
- Servo, Throttling Valves21
Spraymate II Console Functions22
Calibration23
- English/Metric Selection23
- Entering Calibration Values24
- Special Cal for Radar or GPS25
- Determining Wheel Circumference26
- Drive Shaft Speed Sensor Calibration26
- Factory-Loaded Calibration Values27
- Exiting Cal27
"Special" Calibration28
- Units29
- Valve Voltage29
- Material29
- Valve Response Speed29
- Fill Tank Size29
- Tank Alarm Set Point29
- Auto Shutoff On/Off29
- Auto Delay Time29
- Exiting Cal29
Operation30
- Console Switches and Buttons30
- Resetting System Counters32
Prefield System Checkout - Bypass Servo34
Prefield System Checkout - Inline Servo35
Troubleshooting36
- Message/Warnings36
- Console Appears Dead37
- Speed Is Always Zero or Erratic37
- Area Count Is Inaccurate37
- Distance Count Is Inaccurate37
- No Readout of Gallons (Liters)37
  - Or Gallons Per Minute (Liters Per Minute)37
Total Liquid Used Is Inaccurate37
- 6553.5 Message37
- Console Is Erratic in Operation37
- Displayed Measurements Do Not Make Sense37
- Checking Individual Components38
- Plumbing Troubleshooting Chart40
Plumbing Guidelines41
- General41
- Pump Inlet41
- Agitation41
- Servo41
- Flowmeter41
- Pump41
- Valve Purpose and Adjustments41
Appendices43
- Appendix A: Optional Speed Sensor Mounting Installation44
- Appendix B: Fine Tuning Speed/Distance Calibration Value47
  - With Run/Hold Switch Kit Installed47
  - Without Run/Hold Switch Kit Installed48
- Appendix C: Fine Tuning Flowmeter Calibration Value49
- Appendix D: Flowmeter Assembly50
- Appendix E: Radar Adapter Cables51
- Appendix F: Spraymate II Wiring Diagram52
- Appendix G: Spraymate II NH3 SPECIFIC56
- Appendix H: EPD for Spraymate II69
  - Diagram69
  - Installation70
- Appendix I: Conversion Chart71
- Appendix J: Replacement Parts List72

micro-trak SprayMate II - NH3 Specific Installation

Table of Contents

Related product manuals