Need help?Do you have a question about the micro-trak SprayMate II and is the answer not in the manual?
Details the warranty coverage, limitations, and exclusions for Micro-Trak products.
Instructions for selecting a location and mounting the display console unit.
Detailed wiring diagram illustrating all system connections.
Instructions for connecting the system to a 12-volt power source.
Details on battery power connection and ON/OFF switch setup.
Guide for connecting solenoid boom shut-off valves.
Instructions for installing the speed sensor and magnets.
Details on connecting the speed sensor cable to the main harness.
Guidance on installing the flowmeter in the main boom line.
Steps for entering calibration data for various system parameters.
Instructions for calibrating the speed sensor.
Procedure for calibrating the flowmeter for accurate measurements.
Steps for performing a pre-field checkout with a bypass servo.
Steps for performing a pre-field checkout with an inline servo.
Explanation of console error messages and warning lights.
Solutions for problems like dead console or inaccurate counts.
Methods for testing console, harness, and sensors.
Diagnosing issues with speed, flow, and run/hold inputs.
Table identifying plumbing symptoms and possible solutions.
Procedure to fine-tune speed/distance calibration with the kit.
Procedure to fine-tune speed/distance calibration without the kit.
Steps to verify and fine-tune the flowmeter calibration value.
Calibration settings specific to NH3 application.
Steps for calibrating width, speed, and exiting calibration for NH3.
Procedure to fine-tune flowmeter calibration for NH3 application.
Important operational considerations and troubleshooting for NH3.
General| Category | Controller |
|---|---|
| Model | SprayMate II |
| Input Voltage | 12 VDC |
| Brand | Micro-Trak |
| Type | Sprayer controller |
| Display | LCD |
| Operating Temperature | -20°C to 60°C |
To Next Page
