Microgate Optogate - Utility; Basic Settings; Jump Test Configuration

Version 1.9 Page 108 of 170
4.4 UTILITY
4.4.1 BASIC SETTINGS
The Basic Configuration section includes the following items:
4.4.1.1 GENERAL
Language: the language can be changed at any moment during the execution of the
program. Select the desired language from the drop-down menu and press <Save>.
Unit of measurement: allows you to set the unit of measurement type for viewing test
output values. In particular:
Table 1 - Units of Measurement
Type
International
US/UK
Height
cm
inch.decimal
Power
W
W
Specific power
W/kg
W/kg
Steps
cm
ft, inch.decimal
Speed
m/s
ft/s
Acceleration
m/s^2
ft/s^2
Weight
kg
lb
Energy
J
J
Specific energy
J/kg
J/kg
Distances
cm
yards, ft, inch.decimal
Step & Stride
cm
ft, inch.decimal
4.4.1.2 JUMP TEST CONFIGURATION
The flight and contact time configurations include (see 5.3 Invalid Times Management on page 142
for further information on how to use these values):
 Minimum contact time [ms]: allows you to set a minimum contact time in milliseconds; if
the system registers a contact time shorter than this value, it is considered incorrect and
added to the associated flight time (usually the previous one). This control can be
enabled/disabled by inserting the value 0.
 Minimum flight [ms]: allows you to set a minimum flight time in milliseconds; if the system
registers a flight time shorter than this value, it is considered incorrect and added to the
associated contact time. This control can be enabled/disabled by inserting the value 0.