Version 1.9 Page 70 of 170
4.2.2.8 VERTEC LIKE TEST
Main Parameters
Start type: indicates if the start of the test must take place with a ‘status change’ (i.e.
entering or exiting the bars) or with an ‘external impulse’ coming from the jack sockets (start
button, signal light, etc.).
Start: indicates if at the beginning of the test the athlete must be ‘inside the area’ of the bars
or ‘outside the area’.
Stop type: as for the start, the end of the test can take place because of a ‘Status change’ or
an ‘external impulse’, or (in the case of time tests) the end of the test time (e.g. a test “Jumps
15 seconds” will have the Stop type = ‘End of Time’).
Finish: for the Stop type = ‘Status change’ it is necessary to specify if, at the end of the test,
the athlete must be ‘inside the area’ of the bars or ‘outside the area’; in the other two Stop
type cases this field does not appear
Number of Jumps: specifies how many times the athlete must jump (from 1 to 99)
Direction: the only possible option is 'opposite side', i.e. the drums of the bars must be
positioned in the lower part
Secondary Parameters
Minimum contact time [ms]: see above
Minimum flight time [ms]: see above
Maximum flight time [ms]: see above
To Next Page
Loading...
