Version 1.9 Page 74 of 170
4.2.3 DEFINE / EDIT PROTOCOLS
In this section, the protocols to be performed can be defined or edited. The protocols can be
considered as a pre-defined series of tests to be performed in sequence (e.g., one ‘Squat jump’ +
one ‘CMJ’ + one ‘Jumps 15 seconds’).
To create a new protocol, ; select one of the three test macro-typologies (Performance, Gait
Analysis, Rehab) and press <New Protocol>. Insert a mnemonic name and optionally general notes.
Select the tests (in the desired order) that will make up this protocol, using the symbol
If a mistake has been made or a test has to be removed from the protocol, use the symbol
Figure 54 – Creation of a protocol
If you do not remember the parameters of a test definition, place the mouse cursor on it and its
characteristics will be displayed.
After inserting the data, press <Save> and return to the previous section.
The command <Edit Protocol> allows you to edit its name and notes and change its
composition.<Delete Protocol> deletes its definition. Unlike the deletion of a test definition, the
deletion of a protocol does not cause the chain-effect deletion of all correlated tests but only the
connection they had with the protocol. After its deletion, the tests performed by the patients will
be found again as ‘single tests’, no longer related to the protocol.
To Next Page
Loading...
