Version 1.9 Page 59 of 170
Under Utility/Basic Configuration set the ‘Minimum contact time’ to 60 ms. From this moment,
every time new types of ‘Jump Test’ are created, they will have a default value of 60 ms. If this value
is acceptable, no further changes have to be performed in ‘Secondary Parameters’.
Figure 43 - Basic Configuration Parameters
Let’s suppose that for special needs a new test type is needed (e.g., ‘Three Jumps’) with a different
value (e.g., 80 ms). Open <Secondary Parameters>, change the value, and save the test definition.
Figure 44 – Test Definition Parameters
Next, have the patient perform the test ‘Three Jumps’. The single test, having inherited the values
from its type, has the parameter 80 ms. Opening View Test (chap. 4.3.1) and pressing <Settings>,
the following window is displayed:
Figure 45 – Single Test Definition Settings
However it might be necessary to change the parameter ONLY for this single test. Insert for example
75 ms
and press
<OK> or
<Apply>. After
all values
have been
recalculated, the
data in
the table
with
To Next Page
Loading...
