Version 1.9 Page 72 of 170
thanks to the greatly improved algorithms for the automatic recognition of various patterns, it has
been possible to reduce the various types to only two, i.e. 'Normal' and 'Superposed Feet'.
Similarly to the foot change, a rapid method has been added for changing the template directly from
the Gait Report using the relevant button.
In the Secondary Parameters of the 2D Gait Test there are 4 new parameters, which can already be
applied during test definition or during the trial analysis (<Parameters> button).
Minimum Distance Between Feet: parameter required
by the filter algorithms for specific cases
Minimum Foot Width: similar to the minimum foot
length; smaller measures are skipped, because they
are considered spurious
GaitR In and Out Filter: the two parameters expressed
in number of sensors (LEDs) indicate the minimum
number of sensors interrupted by the gait and
triggering the start of the foot contact time (GaitR IN)
and the end of the same time (GaitR OUT). See also
chap. 5.1.6
To Next Page
Loading...
