PRE INSTALLATION
Milli-Q Synthesis/Synthesis A10 16
3-2 PRE INSTALLATION CHECKLIST – “ARMLESS” MILLI-Q
Milli-Q Systems can be ordered from Millipore without the Front Arm and without the Front Point Of Use Dispenser.
These are called “Production” or “Armless” Milli-Q Systems. These Milli-Q Systems always begin with ZMQP
instead of ZMQS.
When a “Production” Milli-Q is ordered (you ordered Millipore Catalogue Number ZMQP ... for example), the
Milli-Q arrives in a box without a Front Arm and without a Front Point Of Use Dispenser.
It is necessary to have a Remote Point Of Use Dispenser with these types of Milli-Qs. Section 3-3 of this manual has
more information regarding the Remote Point Of Use Dispenser.
It may be desired to have Remote Display with the “Production” Milli-Q System. An example of when this would be
needed is when the Milli-Q System is being mounted underneath a Lab Bench. In this instance, the Remote Display
(and Remote Point Of Use Dispenser) could be mounted on top of the Lab Bench.
When you have a “Production” type of Milli-Q System, use the same Pre Installation Checklist on the
previous page. Additionally, you should review the items below also.
Do you have a Remote Point Of Use Dispenser (this item is not part of a ZMQP Millipore Catalogue Number)?
Do you have a Remote Display? (This item is not part of a ZMQP Millipore Catalogue Number)?
Will the Milli-Q System Cabinet and the Remote POU Dispenser be located within 2.5 meters of each other?
Will the Milli-Q System Cabinet and the Remote Display be located within 2.4 meters of each other?
To Next Page
Loading...
