PRE INSTALLATION
Milli-Q Synthesis/Synthesis A10 22
3-5 UNPACKING THE MILLI-Q BOX – WHAT’S INSIDE?
Open the Milli-Q Shipping Box. Use the checklist and illustrations below to make sure all items were shipped and
are accounted for. It is highly suggested to become familiar with the items that are shipped in the Accessories Bag
since these will be used in the Installation Section of this manual.
Check the box
if the item is present.
Contact Millipore if an item is missing.
Do you have …?
Milli-Q Water Purification System
Electrical Powercord
Inside the Accessories Bag:
Black Tubing (8 mm OD) about 5 meters in length. An assembly of blue fittings is attached to one end of
this tubing. The assembly of blue fittings has a Screen Filter inside. The term ‘Screen Filter’ will be used for
the remainder of this manual to refer to the assembly of blue fittings.
Fitting (1/4 inch NPTM on one end and a hose barb on the other end)
Clear Tygon Tubing
Roll of Teflon Tape
3 Elbow shaped fittings (black with yellow coloured collar) (one fitting will be smaller than the other two
fittings)
‘Allen’ Wrench (6-sided black wrench)
Removal Tool (used to remove the Sanitisation Port on top of the system cabinet)
Clear tubing (6 mm OD) about 2.5 meters in length
To Next Page
Loading...
Need help?
General
