Milltronics AIRANGER DPL PLUS - SPECIFICATIONS; AIRANGER DPL PLUS

SPECIFICATIONS
AIRANGER DPL PLUS
Power: » ac: » 100/115/200/230 V ac ± 15%, 50/60 Hz, 15 VA
» dc, optional: » 18.0 - 30.0 V dc, 15 W
Environmental: » location » indoor / outdoor
» altitude » 2000 m max
» ambient temperature » – 20 to 50°C (– 5 to 122 °F)
» relative humidity » suitable for outdoor (Type 4X / NEMA 4X / IP65 enclosure)
» installation category » II
» pollution degree: » 4
Scan Points: » 2 points per AiRanger DPL Plus max.
» frequency independent
Range: » Level Measurement: » 0.3 m (1 ft) to 60 m (200 ft) max.
» Tripper Car: » 1.2 m (4 ft) to 120 m (400 ft) max.
Accuracy: » 0.25% of program range
*
or 6 mm (0.24"), whichever is greater
Resolution: » 0.1% of program range
*
or 2 mm (0.08"), whichever is greater
Memory: » EEPROM (non-volatile) no back-up battery required
Programming: » via removable programmer
Display: » Custom Graphics LCD with 51 mm (2 in) x 127 mm (5 in) viewing area
Temperature
Compensation: » – 50 to 150 °C (– 58 to 302 °F)
» integral transducer sensor
» 2 TS-3 temperature sensors max.
» programmable fixed temperature
Temperature Error: » with compensation: » 0.09% of range
» fixed temperature: » 0.17% / °C deviation from programmed temperature.
Outputs: » transducer drive: » 150 to 315 V peak (transducer model dependent)
» relays: » 4 alarm/control relays
» 1 form "C" SPDT contact per relay,
rated 5 A at 250 V ac, non-inductive
» analog: » 2 outputs max.
» 0.1% resolution
» 0-20 or 4-20 mA, scalable
» 350 ohms max. load (common ground), or
750 ohms max. load (floating common), or
600 ohms, isolated (LIs-1(s) required)
*
program range is defined as the empty distance to the face of the transducer
(P006) plus any range extension (P801).
97/03/01
SPECIFICATIONS
PL-508 101