INTRODUCTION
ABOUT THIS MANUAL
This instruction manual provides information specific to the
AIRANGER DPL PLUS
(Dual Point Level)
monitor.
When references are made to other Milltronics products associated with an
AIRANGER DPL PLUS
(DPL+)
based level measurement system, refer to the associated product instruction manuals, if necessary.
All initial start up information is included in the white pages of this instruction manual. Refer to the grey pages
for additional information or technical assistance, if required.
After reading this INTRODUCTION and completing the physical INSTALLATION, first time system installers
may wish to use the
AIRANGER DPL PLUS Quick Start Guide, PL-431
for step by step start up instructions.
INTRODUCTION
introduces installers and operators to the DPL+, with brief
descriptions of key features.
INSTALLATION
provides a step by step procedure to install and interconnect a
DPL+ based level measurement system.
PROGRAMMING
defines program mode display and keypad functions, and
general programming information.
QUICK START PARAMETERS
details the minimum recommended programming required
to prepare the DPL+ for RUN mode operation.
OPERATION
defines RUN mode display and keypad functions, including the RUN
mode entry procedure and performance evaluation recommendations.
APPLICATION PARAMETERS
details the programmable features which may be used to alter Run
mode display, failsafe, relay, and mA output operation.
ENHANCEMENT PARAMETERS
defines the programmable features used to enhance RUN mode
operation. (Typically used as directed by the Troubleshooting Guide).
TECHNICAL REFERENCE
provides detailed information for complex features and
details 6 specific application examples.
TROUBLESHOOTING GUIDE
provides a quick reference to installation modification and programming
remedies to overcome challenging operating conditions.
SPECIFICATIONS
lists the environmental, physical, and operational
characteristics associated with the DPL+.
PROGRAMMING CHART provides a convenient space to record all programming for
future reference. (May also be used as a complete Parameter index).
REMEMBER!
"Programming is not complete until the Programming Chart is completed".
INTRODUCTION
INSTALLATION
INTRODUCTION
PL-508 5
To Next Page
Loading...
