Milltronics AIRANGER DPL PLUS - Temperature; Temperature Sensor Allocation; Temperature Transducer Allocation

P662 TEMPERATURE SENSOR ALLOCATION
As preset, TS-3 # 1 and 2 are allocated to Point Number 1 and 2 respectively.
To alter this allocation, enter the TS-3 # whose temperature measurement will be used for
the distance calculation of the Point Number displayed.
When both TS-3 temperature sensors are allocated to a Point Number, the temperature
measurements from each sensor are averaged for that vessel.
values: 1 = TS-3 # 1
2 = TS-3 # 2
1.2 = TS-3 # 1 and 2 average
P663 TEMPERATURE TRANSDUCER ALLOCATION
As preset, Ultrasonic/Temperature Transducer # 1 and 2 are allocated to Point Number 1
and 2 respectively.
To alter this allocation, enter the Transducer # whose temperature measurement will be used
for the distance calculation of the Point Number displayed.
When both transducers are allocated to a Point Number, the temperature measurements from
each transducer are averaged for that vessel.
values: 1 = Transducer # 1
2 = Transducer # 2
1.2 = Transducer # 1 and 2 average
P664 (V) TEMPERATURE
View the current vessel atmosphere temperature in C.
This is the value displayed when is pressed in the RUN mode.
If Temp Source (P660) is set to any value other than Fixed Temp, the value displayed is the
temperature measured. If Temp Source is set to Fixed Temp, the P661 value is displayed.
values: -50 to 150
6
PL-508 54