ENHANCEMENT PARAMETERS
This section identifies all DPL+ operator programmable features designed for altering operation to suit
individual operator preferences or overcome measurement difficulties.
Typically, these parameters are only altered as directed by the TROUBLESHOOTING GUIDE . If RUN mode
performance requires improvement, access and alter the following parameters as required.
Otherwise, proceed to .
PARAMETER CATEGORY PURPOSE PAGE
Data Logging to view previous maximum Temperature records 46
Profile Records intended for use by Milltronics Service Personnel 47
Installation Records to identify length of service and power failure occurrence 50
Range Calibration to compensate for measurement offset and/or sound velocity 51
Temperature Compensation to override automatic temperature compensation features 53
Rate to override Measurement Response (P003) 55
Measurement Verification to override Measurement Response (P003) 57
Scanning to override automatic scanning delay or use Aux. Transducer 59
Display Parameters to override the preset display operating characteristics 60
Echo Processing to troubleshoot false echo detection 62
Advanced Echo Processing intended for use by Milltronics Service personnel 64
Test Parameters intended for use by Milltronics Service personnel 72
Measurement Parameters to verify Application Parameter programming 74
Master Reset to reset Parameter Values to factory settings 75
When an Enhancement Parameter is altered, return to the RUN
mode to verify the performance desired is achieved,
before making any other changes.
TROUBLESHOOTING GUIDE
OPERATION
ENHANCEMENT PARAMETERS
PL-508 45
To Next Page
Loading...
