Milltronics AIRANGER DPL PLUS - Auxiliary Reading; Auxiliary Reading Key; Display Delay; Display Parameters

DISPLAY PARAMETERS (P730 to P733, P740)
P730 (G) AUXILIARY READING
Use this feature to display operator selected Auxiliary Readings temporarily.
Select "OFF" to display Auxiliary Readings temporarily. Select "HOLd" to display Auxiliary
Readings until another Auxiliary Reading is selected.
(See OPERATION Keypad for RUN mode Auxiliary Reading selection.)
To select the Auxiliary Reading operation desired.
1. to display the Auxiliary Function symbol.
2. or to display the "OFF" or "HOLd" (preset) option as desired.
3.
If desired, also enter the Parameter Number to default in the Auxiliary Reading display.
values: 000 to 999
P731 (G) AUXILIARY READING KEY
Use this feature to enable a specific Parameter Value to be monitored in the RUN mode.
Enter the Parameter Number whose value is to be displayed in the Auxiliary Reading
field when is pressed in the RUN mode.
(See OPERATION Keypad for RUN mode Auxiliary Reading selection.)
values: 000 to 999 (preset to Material Measurement, P921)
P732 (G) DISPLAY DELAY
Use this feature if the Point Number display scrolls too quickly in the RUN mode.
Enter the delay (in seconds) before the display advances to the next Point Number.
(Point Number display scrolling is independent from transducer scanning.)
values: 0.5 to 10 (preset to 1.5 seconds)
OPERATION
OPERATION
%
PX XX
PL-508 60