Milltronics AIRANGER DPL PLUS - Distance Percent; Master Reset; To Perform a Global Master Reset; To Perform a Point Number Master Reset

P927 DISTANCE PERCENT
Same as P923, plus alternate reading in %
MASTER RESET (P999)
P999 MASTER RESET
A
Global Master Reset (reset all parameters to preset values) should be performed:
» to clear all operator programming from memory.
» after replacing the DPL+ EPROM with a different software revision number.
Following a Global Master Reset, complete reprogramming is required.
A
Point Number Master Reset (reset the non-global parameters of the displayed
Point Number to preset values) should be performed if a Point Number is being reassigned
to a different vessel.
To perform a Global Master Reset:
1. With the Parameter Number field accessed, key in 999,
2. With the Point Number field accessed, key in 00,
3. , "C.ALL" is displayed until the reset is complete.
To perform a Point Number Master Reset:
1. With the Parameter Number field accessed, key in 999,
2. With the Point Number field accessed, key in the Point Number to be reset (1,2, or 3),
3. , "C.ALL" is displayed until the reset is complete.
C
%
C
ENHANCEMENT PARAMETERS
PL-508 75