What to do if my MIMAKI APC-130 shows 'E R R 1 3 PM O V E R'?
If your MIMAKI Plotter displays the error 'E R R 1 3 PM O V E R', it indicates that the polygon buffer overflowed. To resolve this, divide the polygonal data and send the divided data.
What to do if my MIMAKI APC-130 displays [**NO SHEET**]?
If your MIMAKI Plotter displays [**NO SHEET**], it might be because a black sheet is being used. In this case, set the sheet sensor function to OFF.
Why does a communication error occur before receiving data on my MIMAKI APC-130 Plotter?
A communication error before receiving data on your MIMAKI Plotter could be due to turning on the devices in the wrong order. Before turning on the power of the plotter, turn on the host computer first.
Why is my MIMAKI APC-130 not turning on?
If your MIMAKI Plotter is not turning on, it might be due to the power cable not being securely connected. Ensure the power cable of the machine is securely connected to the outlet.
What to do if my MIMAKI Plotter tool is dragged during operation and leaves unexpected cutter imprints?
If the tool is dragged during operation on your MIMAKI Plotter, leaving unexpected cutter imprints, consider the following: * The sheet may be warped. Attach it so that the sheet is not warped. * The tool may not be moving up/down successfully. Turn the power OFF and try to lift/ lower the tool holder by hand. If the tool holder does not move up but remains in the lower position, contact your distributor or our service office. * The side margins of the media beside the pinch rollers are not enough. Provide a side margin of 20 mm or more on each side of the media beside the pinch rollers.
What to do if my MIMAKI APC-130 cut part became a dotted line?
If the cut part on your MIMAKI Plotter is appearing as a dotted line, consider these potential causes: * The screw for the tool holder might be loose. Tighten the knob of the tool holder. * The cutter blade might be protruding excessively. Adjust the blade protruding amount to the proper one. * The blade might be chipped or worn out. Replace the blade with a new one. * The rotation of the blade might be dull. Replace the holder with a new one.
What to do if my MIMAKI APC-130 has misalignment occurs in cutting?
If misalignment occurs during cutting with your MIMAKI Plotter, consider the following possible causes: * The pinch rollers and grit rollers might not securely retain the sheet. Check their position and adjust them. * The selection of clamp pressure (strength mode) may not be proper. * Slack in the roll sheet can cause meandering or skewing. Remove slack and align the roll edges before feeding. * The sheet may be contacting the floor surface. Decrease the cutting speed (SPEED). * Insufficient side margins beside the pinch rollers. Provide a side margin of 20 mm or more on each side. * Sheet expansion or contraction due to environmental factors. Use the pre-feed function to acclimate the sheet.
Procedures for installing the plotter and selecting its location.
Details of the plotter's front and rear parts, operation panel, and key components.
Instructions for connecting cables and understanding the plotter's operational modes.
Overview of operations and steps for installing cutters and pens.
Procedures for powering the device and setting tool conditions.
Steps for loading roll sheets, attaching the basket, and setting pinch rollers.
Performing test cuts, actual cutting/plotting, starting, and stopping operations.
Using jog keys for origin setting, paper cutting, axial correction, and digitizing.
Advanced cutting techniques, troubleshooting abnormal cuts, and sheet handling.
Configuration options for commands, interface, device settings, and operational parameters.
Guidance on identifying and resolving machine failures and common issues.
Explanations of error codes and warning messages with their causes and solutions.
Technical details of the plotter and procedures for cleaning.
Visual diagrams illustrating the plotter's functions and operational flow.
To Next Page
General
