Minebea Intec CAS-SPC Series - Printout Configuration; Configuring Printout Content; Identifiers Configuration

There are several actions that generate the command for outputting data to the
printer port:
– Pressing the p key.
If the operating menu is active, all menu settings under the active menu level
are printed.
– In some applications, pressing a given key (e. g., to save a value or start a
routine) also generates a print command, or it is generated automatically
depending on the application conguration. In this case, a congurable
printout is generated with application-specic data.
The P and l symbols are displayed when data is being output to the printer port.
Conguring a Printout
A printout can be congured in the Setup menu under “Device
parameters:Config. printout
.“ This should be carried out
after conguring the application since some data in the printout is application-
dependent.
You can congure a separate printout for each interface. Each printout is comprised
of dierent information blocks that can be activated or deactivated via multiple
selection in the menu.
For the “Totalizing“ and “Net-total Formulation“ applications, the totalizing/results
printout can be congured independent of the individual/component printout.
The individual information blocks are shown below with detailed explanations.
Samples of complete printouts are provided following the end of this section.
Headers 2 headers each with a max. of 20 characters are available (e. g. for printing the
company name).
Print image example:
ACE HARDWARE
GOETTINGEN
Date/Time
Print image example: 21.01.2016 16:02
To maintain a uniform time (e. g. for documentation within a complete
automatic system), the printing of the time can be suppressed in “Device
parameters:Config. printout:Date/time.
“ When you set
“Date only,“ the time can be added, e. g. from a superordinate control in
order to always have the same time throughout the system. This setting is mainly
designed for communication with a PC.
Identiers Use the “ID“ soft key to enter text in the named IDs via the keypad.
Operating Instructions Combics Complete Scales 107
Data Interfaces