Warnings and Safety Precautions
Combics indicators comply with the European Council Directives as well as
international regulations and standards for electrical equipment, electromagnetic
compatibility, and the stipulated safety requirements. Improper use or handling can,
however, result in damage and/or injury.
t Read these operating instructions carefully before use.
This will prevent damage to the equipment.
3
The protective conductor must not be disconnected for any reason. Use only
standard cables that have protective grounding conductors.
3
If there is visible damage to the equipment or power cord: unplug the equipment
and secure it against further use.
3
Make absolutely sure to unplug the indicator from power before you connect or
disconnect any electronic peripheral devices to or from the interface port.
3
The device should only be opened by personnel trained in accordance with Minebea
Intec guidelines.
3
If you use electrical equipment in installations and under ambient conditions
requiring higher safety standards, you must comply with the provisions as specied
in the applicable regulations for installation in your country.
3
The operator shall be responsible for any modications to the equipment and for
any connections of cables or equipment not supplied by Minebea Intec and must
check and, if necessary, correct these modications and connections.
Information on operational quality is available upon request from Minebea Intec (in
line with norms pertaining to immunity).
3
Do not expose the equipment to aggressive chemical vapors or to unnecessarily
extreme temperatures, moisture, shocks, or vibration.
3
Only clean the device as stipulated in the cleaning instructions: Refer to the
“Care and Maintenance“ chapter.
3
The display value can be aected by extreme electromagnetic inuences. Once the
disturbance has ceased, the instrument can be used again in accordance with its
intended purpose.
Danger of Explosion!
1
Do not use device without option Y2 in hazardous areas.
Option Y2 described in instructions 98647-004-70.
4 Operating Instructions Combics Complete Scales
Warnings and Safety Precautions