Minebea Intec CAS-SPC Series - Configuring Weighing Platforms; Service Mode Operations

Configuring Weighing Platforms
Service-Mode
Purpose The Service mode enables access to additional menu items in the Setup menu
which are not displayed when the Service mode is not active. The most important
calibration and adjustment work for the indicator and for the connected weighing
platform can be carried out in the Service menu.
When the Service mode is active, an “S” is shown in the top right-hand corner of
the display. To deactivate the Service mode, restart the indicator (turn the indicator
o and back on again).
Activating the Service Mode
t Press e to turn on the device.
y When turned on the scale is in an application program.
t Enter the service password (see Appendix General User Password) and press
M to conrm.
y The device in now is Service mode. An “S“ appears in the top right-hand
corner of the display.
t Press the “q“ soft key several times to select the “Device
parameters
“ line.
t Press the “O“ soft key.
y The “Device“ submenu will open.
t Select and open the corresponding submenu. Repeat this procedure until the
desired menu item in the lowest menu level can be opened.
t View or change the menu item (conrm with “l“) and use “o“ to return to the
previous menu.
t Press M or “oo“ to exit the Setup menu.
Exiting Service Mode
Turn the device o and then on again to return to the normal application mode.
If you exit the Setup menu without changing settings by conrming with M or
the “oo“ soft key, the Service mode will remain active. Press the M key to
re-open the Setup menu.
Operating Instructions Combics Complete Scales 21
Configuring Weighing Platforms