Minebea Intec CAS-SPC Series - Setup Overview; Setup Overview (Parameters)

Setup Overview (Parameters)
W = User-dened setting
Setup
Application parameters: Please refer to the “Basic Application Programs” manual
Fn key function
o O
Unit conversion
SQMIN (only possible when the display has been turned on in the “Device parameters:SQMin“ menu item)
Device parameters
WP 1
RS-232
1
)
SBI standard
SBI veriable
o IS-232
ADC-232
RS-485
1
)
o IS-485
ADC-485
Internal
Calibration/Adjustment
CAL key function
o Ext. cal./adj.; factory-def. wt.
Ext. cal./adj.; user-dened wt.
Key blocked
Cal./adj. sequence
Cal. then auto adjust
o Cal. then manual adjust
isoCAL function
3
)
o O
Adjustment prompt
Activate external adjustment
2
)
o Activated
Deactivated
Parameter for external weight
Cal./adj. weight:
Calibration/adjustment unit
Grams /g
Kilograms /kg
Tons /t
Pounds /lb
Adapt lter
Min. vibration
o Normal vibration
Strong vibration
Extreme vibration
Application lter
o Final readout
Filling mode
Low ltering
Without ltering
Stability range
1/4 digit
1/2 digit
1 digit
2
)
o 2 digits
2
)
4 digits
2
)
8 digits
2
)
o = Factory settings
1
) Equipment version: – then blocked internally
2
) Not available on devices veried for use in legal metrology
3
) Only when operated with Minebea Intec IS weighing platforms or an external ADC
Operating Instructions Combics Complete Scales 63
Operating Design