Minebea Intec CAS-SPC Series - Data ID Codes; Assigning and Managing Data ID Codes

Data ID Codes
You can assign codes (such as product name, batch number, etc.) for identication
of measured values in all application programs.
Features – Assign up to six ID codes.
– Assign both a name and a value to each ID code.
– Displaying individual IDs: press the “ID“ soft key.
– The name is left-justied and the value is right-justied on the printout. If the
entire code is too long for one line, additional lines are printed.
– Enter ID code names in Setup under: “Device
parameters:Config. printout:ID codes
.“
– The name can have a max. of 20 characters. When entering the ID value, no
more than 11 characters are displayed during input; however, all 20 characters
are printed.
– Enter up to 21 characters for the value of the ID code. Press the “ID“ soft key
to activate the input mode.
– Enter the rst ID value directly through the numeric keypad. Press the “1st
ID
“ soft key to save the value.
– Individual characters of the ID can be deleted using the ( key. Complete ID
code values can be deleted using the “Delete“ soft key.
– If both the name and value elds are empty, no ID code is printed.
– In the Setup menu, you can congure when and whether ID codes are printed
(see included “Application Programs“ instructions, “Conguring Printouts“).
Settings for individual ID codes
Setup menu: “Device parameters:Config. printout:
Factory settings for ID code names: ID1: “ID1“
ID2: “ID2“
ID3: “ID3“
ID4: “ID4“
ID5: “ID5“
ID6: “ID6“
There are no factory settings for ID code values.
94 Operating Instructions Combics Complete Scales
Operation