Minebea Intec CAS-SPC Series - Setup Menu Overview; Setup Menu Structure in Service Mode

22 Operating Instructions Combics Complete Scales
Configuring Weighing Platforms
Overview of the Setup Menu in Service Mode
o = Factory setting
x = User-dened setting
Service password entry Setup Application parameters, please refer to the “Basic Application Programs” manual
Fn key “Setup Overview (Parameters)“
Device parameters
Info, see the “Setup Overview (Parameters)“ section
Language, see the “Setup Overview (Parameters)“ section
Setup access with service password
Device parameters
WP1
RS-232
1
)
SBI standard
SBI veriable
o IS-232
ADC-232
RS-485
1
)
o IS-485
ADC-485
ADC conguration (see the “Setup Menu for ADC Conguration“ section)
Calibration/Adjustment
CAL key function
o Ext. cal./adj.; factory-def. wt.
Ext. cal./adjust.; user-dened weight
Ext. lineariz.; factory-def. wts
Ext. lineariz.; user-def. wts
Set preload
2
)
Delete preload
2
)
Key blocked
Cal./adj. sequence
Cal. then auto adjust
o Cal. then manual adjust
isoCAL function
3
)
o O
Adjustment prompt
Activate external adjustment
2
)
o Activated
Deactivated
Parameter for external weight
Cal./adj. weight:
Lin. weight 1...4:
Adjust without weights
2
)
Input parameters
Nominal load:
Resolution:
Sensitivity 1…4:
Save parameters
Yes
o No
Geographical data
2
)
Input parameters
Geographical latitude
Altitude
Gravitational acceleration
Save parameters
Yes
o No
1
) Equipment version: – then blocked internally
2
) Not available on devices veried for use in legal metrology
3
) Only when operated with Minebea Intec IS weighing platforms or an external ADC