Minebea Intec CAS-SPC Series User Manual

Installation
3
Warning when using pre-wired RS-232 connecting cables: RS-232 cables purchased
from other manufacturers often have pin assignments that are incompatible with
Minebea Intec products. Be sure to check the pin assignments against the chart
in this manual before connecting the cable, and disconnect any lines identied
dierently from those specied by Minebea Intec.
3
Connect only Minebea Intec accessories and options, as these are optimally designed
for use with your device. Therefore, do not use any proprietary solutions. The
operator shall be solely responsible for installation and testing of any modications
to Minebea Intec equipment, including connection of cables or equipment not
supplied by Minebea Intec. Information on operational quality (in line with norms
pertaining to immunity) is available on request.
t If you have any problems with your device, contact your local Minebea Intec
oce, dealer or service center.
IP Protection Rating
IP Rating – CAWxS models are rated to IP67.
– CAS3E* /CASE-SPC/CASLE-SPCmodels:
platform IP65, indicator IP69K.
– CAS3E-64ED-S, CASLE-SPC-06HCE models:
platform IP43 (Some models IP43), indicator IP69K.
– CASLE-SPC models: platform IP65, indicator IP44.
– CAS3G* models: platform IP67, indicator IP69K.
– CAWxS models are rated to IP69K with the “I69“ option.
– Complete scales with secured protective caps must be installed and tested by a
certied technician.
– If you install an interface port or battery connection after setting up your
indicator, keep the protective cap in a safe place for future use. The cap protects
the interface connector from vapors, moisture and dust or dirt.
Use in Legal Metrology
– When the indicator is connected to a weighing platform and this equipment is
to be veried, ensure that the applicable regulations regarding verication are
observed.
– When connecting Minebea Intec weighing platforms, observe the Declaration of
Conformity with the list of permitted weighing ranges.
– A sticker with the “Minebea Intec“ logo was axed to the indicator as a
control seal following verication. This seal will be irreparably damaged if
you attempt to remove it. This will nullify the verication‘s validity. In this
case, re-verication would be required in compliance with all relevant national
regulations and laws.
Operating Instructions Combics Complete Scales 5
Warnings and Safety Precautions

Minebea Intec CAS-SPC Series Specifications

General

Brand	Minebea Intec
Model	CAS-SPC Series
Category	Scales
Language	English