Minebea Intec CAS-SPC Series - COM 2 and UNICOM Configuration; COM 2 and UNICOM Interface Settings; Analog Output Configuration

Device Parameters
COM 2 similar to COM 1
UNICOM (optional interface)
o O
WP 3
o RS-232
SBI standard (9600 baud)
SBI veriable (9600 baud)
o IS-232
ADC-232
RS-485
o IS-485
ADC-485
Data communications
o SBI similar to COM 1
xBPI-232 similar to COM 1
xBPI-485 address 0 to 31 can be selected
SMA similar to COM 1
Probus address: 0 to 126 can be selected,
DeviceNet MAC ID: 1 to 62 selectable
Ethernet
Printer 1
1
) Similar to COM 1
Printer 2
1
) Similar to COM 1
Analog output
Analog output: value
Net value
o Zero to max load
Min./Max.-values
Gross value
o Zero to max load
Min./Max.-values
Analog Out: Error Signal
o High level (20 mA)
Low level (0/4 mA).
When menu is open or during
calibration
(0/4 mA) on this interface.
Analog Out: Trim
o Min. (0/4 mA) Trim
Max. (20 mA) Trim
o = Factory settings
1
) Max. 2 Printers can be configured
70 Operating Instructions Combics Complete Scales
Operating Design