19
4-4-2. Fine adjustment of zero and span
When key pressed from display
is displayed.
In executing the zero fine adjustment, proceed the
operation of a). In case of executing the span adjustment
only, press key, and proceed the operation of b)
after displaying .
a) Fine adjustment of Zero
Press the key. Display becomes .
“ ” is the present measuring value, and it can be
displayed up to 1/10 digit.
ex. Without a decimal point 0 to 6000 -> 0.0 to 6000.0
With a decimal point 0.0 to 600.0 -> 0.00 to 600.00
Please set the display to “zero” after the condition which
nothing is put on the measuring point.
：Increase the measuring value.
Increase continuously by keeping key pressed.
：Decrease the measuring value.
Decrease continuously by keeping key pressed.
：Interrupts the setting, and returns to
display.
：Memorizes the display value, and proceed to
the next step.
After the zero fine adjustment, press the key.
Display becomes . In case of executing the
fine adjustment of span, proced the operation of b).
Otherwise, press the key, and proceed the operation
of c) after displaying .
b) Fine adjustment of span
Put the weight which can be put on the measuring section
under the maximum capacity.
is displayed by pressing the key.
“ ” is the present measuring value, and it can be
displayed up to 1/10 digit.
Please set the display to become the same value with the
weight put on the measuring section.
After the fine adjustment of span, proceeds the operation
of c) after the display by pressing key.
[A]
[B]
To Next Page
Loading...
Need help?
General
