V
2. Power supply
Warning
Warning
Caution
3. Application note
Caution
Caution
Caution
Caution
Caution
Be sure to check that the power supply is off in connecting each cable. If the work is done while the power is on, there may have the case that
electric shock to the operator or even may have damage to the instrument.
Before supplying the power, check that the indication of power supply voltage/specifications for the instrument and the power going to supply
should be the same. If they are not equal, contact with Minebea. If you use the instrument without checking them, it may cause a damage in the
instrument or electric shock to the operator.
Earth wire should be grounded securely.
When earth wire is not connected, it may cause a malfunction of the instrument or electric shock to the operator.
Before using a new instrument or exchanging the strain gage applied transducer for a new one, be sure to make calibration. If calibration will not
be made, the correct measuring results may not be obtained nor which may cause malfunction in the instrument and there may exist damage
in peripheral equipment. Besides, even though calibration has been made, there may occur the similar case when the results are not correct, so
make calibration, again.
When change of setting is made carelessly on the instrument during measurement, the correct measuring results may not be obtained and it
may cause malfunction in the instrument and even have the possibility of damage in peripheral instruments.
In case of using the instrument, check that the connections are executed properly. If not connected properly, the correct measuring result will
not be obtained, nor it may cause malfunctions of the instrument, damage to the peripheral equipment or even more serious accidents.
Do not shock the instrument such as throwing something on it.
If neglected, it may cause destruction of the parts and damage to the electrical circuits.
Do not remove the case cover of the instrument, nor peel off the panel sheet nor take the instrument into pieces. If neglected, it may cause a
damage to the case and the panel sheet and even have the possibility of damage to resist to environments or operational performances.
At the time of shipment from the factory, the instrument has been plated with a clear sheet on the panel sheet for protective purpose.
In case of application, use the instrument after removing the clear sheet first.
Do not push the panel sheet on the instrument with the excessive strong force nor push it with sharp edge object such as a driver. If
neglected, it may cause damage to the panel switch and even have the possibility of damage to resist to environments or operational
performances.
To Next Page
Loading...
Need help?
General
