47
8-8-6. Clear of the accumulated value and count.
Press the key in the condition of the accumulated
value display. (During the display of the accumulated
count, the clear operation cannot be proceeded.)
is displayed, and press the key.
is displayed, and the accumulated
value and accumulated count is cleared at the same
time.
Please press the key, and return to the
measurement mode.
8-9. Setting of the external control input operation
The function can be controlled from the outside by the “INPUT” connector from the rear panel.
The function of each pin is set by function F-60 to F-66.
Please refer to the paragraph 2-3. Connection of the external control input.
Default has set to “Operation OFF” for all from F-60 to F-66.
8-10. Memory clear
Memory clear is executed by function F-99.
The setting contents of the function is returned to the default setting.
When the key is pressed with displayed, becomes a blinking display.
At this time, please press the key to discontinue a clear memory.
It becomes a stand-by mode, and a clear memory is not executed.
When is a blinking display, the display section is turned off by pressing the key, and it
becomes display, the operation of memory clear is completed.
Measurement mode
To Next Page
Loading...
Need help?
General
