46
8-8-4. Switch to accumulation display
By pressing the key from the normal measurement
mode, the display becomes , and
the accumulation mode is entered.
The display automatically displays the accumulated value
about one second later. (Up to 9 999 999)
By pressing the key, displays, and
the display automatically display the accumulated count
about one second later.(Up to 999 999)
The accumulated value and count are switched and
displayed with the key and the key.
Again, by pressing the key, it becomes to the normal
measurement mode.
8-8-5. Display range of the accumulated value and count
The display range of the accumulated value is from –1999999 to 9999999.
The display range of the accumulated count is from 0 to 999999.
The upper limit of accumulated value disregards the displayed decimal point.
ex. When the position of decimal point is 0.0, the upper limit of accumulated value is 999999.9.
● The load display blinks once in both cases manual operation/automatically in accumulating. At the same time, one accumulated count is
added.
● When there is an accumulation data, the “ACCUM.” mark of the condition display lights on.
● When exceeding the display range of the accumulated value or the accumulated counts results, the accumulation is not executed.
The “ACCUM.” mark of the condition display lights on.
● The accumulating operation is prohibited unconditionally at the OL display or the –OL display.
● When the accumulated value and the accumulated count exceeding the display range results, the additive of the count is not executed.
As the accumulating condition display blinks, please execute to clear the accumulated value and count.
Measurement mode
Shifts automatically
one second later.
Accumlated
count
Clear of
accumulation value
Measurement mode
Shifts automatically
one second later.
Accumulation
value
To Next Page
Loading...
Need help?
General
