VI
History of revision
Date Instruction manual No. Details of revised point
2003/03 DRW. NO.EN294-1185 First Version Ver.2.000
2003/04 DRW. NO.EN294-1185A
Due to ECN NO. FN03-02048.
*Changed the “minimum scale “ to “scale interval”.
*Changed the “meter “ to “measuring section”.
*Changed the “measurement display “ to “load display”
*In the section 6-9-5,changed the “minimum scale” to “scale
interval in calibration”
*Change the “OVR.” to “OVER” in the section 13-2-8 and 15-3.
*Corrected the “ID No.” to “Address” in 13-3-12.
*Added “Sending data: binary code BCD” on the table in 12-1.
2003/08 DRW. NO.EN294-1185B
Due to ECN NO. FN03-02107.
– Correction –
13-3-13. write “Contents” instead of Japanese
2004/11 DRW. NO.EN294-1185C
Due to ECN No.FN04-02169
・Correction of the error/mistake in the contents.
・Correction of a gravity acceleration setting value
Nov. 2005 DRW. NO.EN294-1185D
Due to ECN No.FN05-02135
*Add the clause “When this is used in Japan domestic, the voltage
that exceeds AC125 V cannot be supplied by the limitation of
“Electrical Appliance and Material Safety Law”.
May. 2010 DRW. NO.EN294-1185E
Due to ECN No.FN10-01019A
- Addition -
Panel mounting gasket is added.
Oct. 2010 DRW. NO.EN294-1185F
Due to ECN No.FN10-02140
- Change -
Minebea logo is changed.
Jan. 2011 DRW. NO.EN294-1185G
Due to ECN NO.FN11-02001A
- Correction -
13-3-10. “DE-9S-N (JAE)”
to “DE-9S-NR by JAE or equivalent.”
Due to ECN No.FN11-02016
ROM Ver.3.100 or lator.
- Addition –
7-2. ”Function of the function date”
Key lock F-08 is added to the table.
8-4. “Key lock function” is added.
8-4-1.”Key lock” is added.
19. “Setting table for functions”
F-08 is added to the table.
Update of Index.
To Next Page
