43
8-4. Key lock function
This function sets whether the operation of each key in the front panel is effective or invalid to prevent the
various keys from the wrong operation.
8-4-1. Key lock
The function of F-08 sets whether the key operation of “set”,”Accum./ ”,”PRESET TARE/ ”,
”TARE/ “ and “NET/GROSS/ “ is effective or invalid.
The key lock function becomes effective only in the measurement mode.
Default is set “Invalid”.
8-5. Stability detection
When the change width of the load display is within the data width set by function F-10, and when the condition
continues for the time set by function F-11 or more, the stability detection is the function to judge the
measuring value being stable.
8-5-1. Data width of stability detection
The data width of stability detection can be set by function F-10.
Setting range : 0～9 Unit : 0.5D 0：OFF
Default has set “4”.
The data width is obtained in the display conversion by the below formula
“Data width of stability detection”＝ “Setting value of F-10” x 0.5 x “The scale interval”
When the setting of function F-10 is “4”, and when the scale interval is “D = 2”, it will become as follows;
“Data width stability detection” = 4 x 0.5 x 2 = 4D
To Next Page
