Minebea CSD-904-EX - Operation; Changeover of Mode

9
3. Operation
3-1. Changeover of mode
This unit has various modes according to the operating situation.
Proceed the changeover of the mode by the key operation.
● When the load cell output exceeds ±10 % of weighting by the power on zero function after checking the display, the display becomes the
error indication of “ ”. At this time, if the key is pressed, the display compulsorily becomes a load display. Refer to the
paragraph 6-6. Power on zero.
Power ON
Display check
(All lights on)
display of
Measurement mode
(Display measuring value)
Stand-by condition
(Lights off the measuring value display)
Set mode
①Refer to the function mode
②Refer to the C function mode
Measurement mode
(Display accumulated value)
⑤Refer to the comparator mode
＋
＋
③Refer to the calibration
mode
④Refer to the check mode
display of
display of
display of