72
Configuration
Command Menu-->Dialer-Config
11.12.5Dialer Enable/Disable
Command Menu-->Dialer-Config
Ring Detect
Command Menu - Dialer-Config - Time Parameter
2.Cellular report date
0 ->Default
Use this menu to set the test
report date for the cell phone
setup. If the date is set to 0, there
will be no test reporting for cell
phone or regular telephone line.
Other settings could be anywhere
from 01-28, representing which
day of the month the test should
be performed. When a cell phone
service is employed for the panel,
it should only be connected to
telephone line #2 CO interface.
Also, the dial tone detection
feature of line #2 should be
disabled for a cell phone
application.
Command Menu - Dialer-Config - Time Parameter
3.Auto test time
00:30 ->Default
Use this function to set the time
for auto test. This test has to be
performed at least once a day to
send the test report to the
monitoring station. The time is in
24 hour format, which means
00:30 is 30 minutes after
midnight.
Please do not use the following
test times: 00:00, 01.55, 02:00
and 03:00.
The auto test time can be
configured to:
12:00 AM to 5:59 AM: test every
24 hours
6:00 AM to 11:59 AM: test every 6
hours
12:00 PM to 23:59 PM: test every
12 hours
[X] ENABLE ->Default
[ ] DISABLE
The dialer is enabled by default.
When the dialer is enabled or
disabled, a warning message
appears.
Warning: The dialer cannot report
any event to the monitoring
station if it is disabled.
[ ] Disabled
[ ] 1
[ ] 2
[ ] 3
[ ] 4
[X] 5->Default
[ ] 6
[ ] 7
[ ] 8
Use this menu to select the
number of rings on which the
panel’s modem will answer. The
default number of rings is five.
The maximum number of rings is
eight.
If you select the “Disabled” option,
the modem will be disabled and
the panel will not pick up the
incoming call.
------Warning-------
Dialer Disabled!!!
To Next Page
Loading...
Need help?
General
