62
Configuration
Command Menu --> FA-300 Config
11.4.7 Default Configuration
11.5 Config. Info. (Command Menu)
Press the up and down arrow buttons to
select between Y/N. Press ENTER to restore
the default configuration.
Use this menu to load the default configuration in the panel.
Warning: When you load the default configuration, the
previously programmed configuration is lost permanently.
Press the down arrow button to see more
information.
Configuration type shows how the panel was configured.
Factory default means the panel has not been configured;
it is as it came from the factory.
Front Panel means it was configured at the panel.
Serial Port means the configuration was done from a
computer through the serial port.
Modem means the configuration was done remotely
through a modem.
If you upload a job to the panel using the FA-300
Configuration Utility, the job name appears on this screen.
The job name can be up to a maximum of 20 characters.
Press the down arrow button for further
information.
If you upload a job to the panel using the FA-300
Configuration Utility, the technician’s name (ID) appears on
this screen. The technician ID can be up to a maximum of
10 characters.
Press the down arrow button for further
information.
This screen shows the date and time that the configuration
was last changed.
This screen shows the version of the FA-300 Configuration
Utility. It displays 0.0.0.0 if the FA-300 Configuration Utility
was not used.
Load the default
settings? Y
Default settings
have been loaded
Configuration type:
Factory default
Cfg. Date and Time:
hh:mm day year:mm:dd
Cfg. Tool S/W Vers.:
Version:x.x.x.x
To Next Page
Loading...
Need help?
General
