Mitel 112 User Manual

Table of Contents
If this feature is enabled, the handset will not respond to incoming calls. The “Do not disturb”
icon
is displayed in the status bar when “Do not disturb” is enabled..
HIDE NUMBER
The “Hide Number” feature allows you to make calls such that the called party cannot see
your caller ID.
• Off: When the “Hide Number” function is set to “Off” with the left softkey, the caller ID of
the handset is displayed to the counterpart of the call.
• On for next call: If this function is enabled, the caller ID will be hidden for the counterpart
only for the next outgoing call and displayed again for all following calls.
• Always on: With “Always on” enabled, the caller ID is hidden from the called party for all
outgoing calls.
Note: When “Hide Number” is enabled, the base sends SIP header “Privacy: id” to address
sip:anonymous@anonymous.invalid
The PBX must support anonymous calls; otherwise, the call is rejected.
CALL FORWARD
The “Call Forward” feature enables the user to forward all incoming calls in different cases as
described below.
29

Mitel 112 Specifications

General

Protocols	SIP
Lines	2
Headset Port	Yes
Volume Controls	Yes
Speakerphone	Yes
Wall Mountable	Yes
Ethernet Ports	2 x 10/100 Mbps
Power	PoE