Handset Operations Manual
TROUBLESHOOTING
This troubleshooting section contains information on how to solve some operational problems
that you may experience on the handset.
OPERATIONAL PROBLEMS
State: The handset does not ring
Problem cause: The sound off icon is seen in the status bar; hence, the handset is silent
mode.
Action:
Increase the volume in Audio Settings, or long-press the # key in idle.
Note: If the Audio Settings is greyed out and cannot be changed, it is because the silent mode
is enabled by long-pressing the #-key. Please, long-press the # key in idle to disable this silent
mode.
State: The handset does not respond when pressing on the keys
Problem cause: Keylock featire is enabled, and a “Press and hold ∗” screen is displayed
when pressing any key.
Action:
Long-press (press for more than 2 seconds) the ∗ key.
State: The handset shows “Searching” in the display
Problem cause: The handset is out of the coverage area of the base station system.
Action:
Please move the handset back in coverage of the base system.
44
To Next Page
Loading...
