Mitel 112 User Manual

Handset Operations Manual
SILENCING AN INCOMING CALL
When the handset is alerting, press the “Silent” softkey to stop the ringing. The handset will
continue to alert, but without any ringing.
ENDING A CALL
To end an ongoing call press the red “On-hook” key , and the call is terminated. The
duration of the call is shown in the display. Furthermore, this duration time can also be
viewed from the call list where the call is stored.
Note: If one call is active and another call is on hold, then the active call is terminated when
pressing the red “On-hook” button and the handset automatically returns to the call on hold. The
call on hold is now active and the user has to press the red “On-hook” button again to terminate
this call.
INITIATING A CALL
A call can be initiated from different locations on the handset:
- By entering the number directly from idle
- From the “Contacts” menu
- From the “Calls” menu
- From the “Central Directory”
How to initiate a call from these different directories is explained in the following sub sections.
INITIATING A CALL FROM IDLE
To initiate a call from idle:
1. Enter the number of the person you want to call when the handset is in idle.
2. Press the green “Off-hook” button
to call the number.
3. The handset displays the “Calling” screen as shown above.
4. When the called party answers the call, the screen shows “Connected” and the two parties are
now in call.
36

Mitel 112 Specifications

General

Protocols	SIP
Lines	2
Headset Port	Yes
Volume Controls	Yes
Speakerphone	Yes
Wall Mountable	Yes
Ethernet Ports	2 x 10/100 Mbps
Power	PoE