Mitel 470 - Page 237

Operation and Maintenance
237
Mitel 470 as of R4.1
syd-0585/1.2 – R4.1 – 08.2016
TLS certificate update failed The update of the TLS certificate for an SIP
node or SIP endpoint via FTP has failed and
needs to be renewed manually.
If the endpoint type is = 0 (Mitel), then is param-
eter 2 = node ID.
If the endpoint type is = 1 (3rd party), then the
remaining parameter data contains the first
eleven characters of the certificate name.
Type of endpoint
(0: Mitel, 1: 3rd
party), node ID or
certificate name,
date, time
critical
(negative,
with
match)
TLS certificate update suc-
cessful
A TLS certificate for a SIP node or SIP endpoint
was successfully renewed.
If the endpoint type is = 0 (Mitel), then is param-
eter 2 = node ID.
If the endpoint type is = 1 (3rd party), then the
remaining parameter data contains the first
eleven characters of the certificate name.
Type of endpoint
(0: Mitel, 1: 3rd
party), node ID or
certificate name,
date, time
critical
(positive,
with
match)
TLS certificate was
generated: Upgrade non-
Mitel endpoints now
A TLS certificate has been generated. If genera-
tion is manual, the certificate must be imported
manually into the Mitel SIP nodes. The certifi-
cate must always be imported manually on all
non-Mitel nodes and non-Mitel endpoints.
Date, time
Normal
(without
match)
Too few FoIP channels Setting up a fax connection via T.38 failed
because no FoIP channel is available.
Available FoIP chan-
nels on node
Normal
(without
match)
Too few licences for IP sys-
tem phones
A MiVoice 5361 IP / 5370 IP / 5380 IP was una-
ble to register because there are too few IP sys-
tem phone licences.
Date, time
Serious
(negative,
with
match)
Too few licences for PMS
interface
Either the Hospitality PMS Interface licence is
missing or the number of Hospitality PMS
Rooms licences available is insufficient.
Number of licensed
rooms, number of
configured rooms,
date, time
Serious
(negative,
with
match)
Too few VoIP channel
licences
Connection setup failed because the licence
limit for simultaneously active VoIP channels
has been reached.
No. of licensed VoIP
channels, Date, Time
Normal
(without
match)
Too few VoIP channels An user is trying to set up a connection that
requires one or more VoIP channels which are
currently not available.
Available VoIP chan-
nels on this node,
date, time
Normal
(without
match)
Too many errors with the
same ID
An unusual amount of errors (more than 50 per
hour) with the same error ID have occurred.
Error ID, date, time
Normal
(without
match)
Too many event messages Number of message types exceeds limit entered
in the table on:
• "Synch. "Synch.loss on BRI/PRI"
• "Outgoing Call Rejected"
• "No response from network"
Date, time
Normal
(without
match)
Too much user data System capacity exceeded Date, time
Critical
(without
match)
Event message Trigger condition Details
1)
Severity